![]() ![]() As a full Centrifuge tank produces 8 Resin, this produces a total of 2 scrap, or 2/3rds the output of the above Ceramic option. The most efficient automated conversion is using a Centrifuge to produce Resin, then using a Small Printer to produce Small Canisters, which scrap into 0.25 Scrap each. Unfortunately, however, this method cannot be automated, as the Small Printer cannot print Drill Mod 1's.Each Drill Mod 1 is worth 0.5 Scrap, with the net result of 3 Scrap per full Soil Centrifuge tank. Using the centrifuge to obtain 6 Clay, smelting them into Ceramic with the Smelting Furnace and creating 6 Drill Mod 1. The Soil Centrifuge is a good source for Scrap.In total, the Centrifuge requires approximately ~45-46s to complete a full cycle for a resource that is produced at a rate of 8 per fully-filled cycle, ~44s for 6 per cycle, ~42s for 4 per cycle, ~41s for 2 per cycle, and ~40-41s for 1 per cycle.Thus resources that produce more per Centrifuge cycle also take slightly longer to run each cycle. Resources that produce at a lower number per Centrifuge cycle require more soil per tube, but the time increase to fill the tubes does not completely offset the time saved from filling fewer tubes before each Centrifuge cycle. The overall process, including the time to load two Canisters worth of Soil from a Medium Soil Canister, as well as the time for the machine head to fill each of the necessary tubes in the Centrifuge, varies depending on the resource selected and thus the number of tubes that need to be filled.The Soil Centrifuge takes 30.375 seconds to complete the process, not including start up.For bulk production, use a Medium Fluid & Soil Canister in combination with a Small Canister to continuously feed soil to the Centrifuge.The Auto Extractor was first shown off on the JSES Dev Twitch stream.The following table lists the resources that can be extracted from a full Soil Centrifuge tank (two Canisters of soil):Įach full operation consumes 182.25 Units of power, regardless of how many items the machine produces.The thumping of an active Auto Extractor, if the player is within horizontal range of it, can be heard far underground if one listens.An Auto Extractor does not show up on the Compass, so a Beacon is advisable to mark the location if placed far from the player's base.This can be useful when using an Auto Arm with Auto Extractors placed sideways or upside down. A Tall Storage may be placed on the top of the Auto Extractor so extracted resources are further away.The Auto Extractor has a Tier 2, which is meant for a Medium Resource Canister, Medium Storage, or Medium Storage Silo, to add extra storage without using an Auto Arm.Organic patches are not true deposits, so the Auto Extractor cannot extract from them.The green bars on each side of the Auto Extractor indicate how much resource is left to extract in the current deposit.The extractor must be turned off before being connected, as it will still drain power when attached to the rover. This allows it to be transported via a large rover without packaging. The Auto Extractor is able to attach directly to Tier 4 attachment slots.The Auto Extractor requires 6 cycles to complete one nugget.This will fill up its two slots in 111 seconds, a Medium Storage in 7.4 minutes, a Medium Storage Silo in 22.2 minutes, a Medium Resource Canister in 29.6 minutes, and a Large Resource Canister in 6 hours and 10 minutes with the use of an Auto Arm. At full power, the extractor takes 55.5 seconds to create a single nugget of extracted material.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |